Installation Details Of Anti-skid Chain

Anti-skid chains Due to the freezing weather and snow on the road, many cars are equipped with anti-skid chains to avoid accidents. The principle of anti-skid chain is to concentrate the gravity of the vehicle on several points of the iron chain, generate huge pressure, and roll through the ice and snow layer directly to the road surface, thus increasing the friction of the chain and increasing the safety factor of the vehicle. The editor found some common sense about anti-skid chains and hoped that all citizens could travel safely. Installing anti-skid chains is a skill course that most people may never use in life. But as you live in a cold climate, it is very useful. It may sound daunting, but in fact, installing and removing the chain is a very fast process, even in cold weather. In 15-30 minutes, under the guidance of experts, you can drive safely and reliably in winter. It is better for you to install and remove the chain in the driveway or some relatively safe places. Of course, when you have to install or remove it on the way, it is necessary to be on a safe and flat road. No matter where you are, make sure that you have at least 10 feet of space in front of and behind the car to allow you enough space to move the chain. At the same time, before your hand touches any place near the tire, please ensure that your parking brake has been activated to avoid accidents. It is a good idea to use wood blocks to support the tire as an additional protective measure. Last but not least, clean up the excess snow on your tires. First of all, make sure your car is driven by the front wheel or the rear wheel, because the chain must be hooked on the main group of tires. When you know which set of tires you need to apply the chain to, try to remove the snow around the tires to make a flat surface. Spread the chain under the car and place the first gear of each chain on the ground against the tire. Make sure that the side of the chain full of particles faces the ground, which is the part of the chain with the maximum traction. If you are a rear-wheel drive car, you should bite the chain backwards. If it is the front wheel, push it forward. Check whether each tire is fixed on the chain, and each side is overlapped with a gear. Then get on the car, start the engine, slowly and carefully take the chain to move the car forward or backward about 2 feet. Once your tire is positioned on the chain at right angles, pull off the ports lapped on the top of the tire. Each end must be a device that completely matches the entire chain gear. Leave yourself 1 to 2 inches of space, and then fasten the device through the two opposite sides of the chain link. Each rubber ring of the chain has 4 metal hooks evenly distributed around it. Each metal hook on the rim of the wheel hub cover of the tire is fixed crosswise in a crisscross manner. This ensures that your chain does not slip. Now the chain should be safely installed and can provide traction for you on the snowy road. However, don't think that your chain can guarantee you to drive fast in the harsh driving environment. Start slowly and pay attention to the sound made by the car. It may remind you that the chain is loose or the tire is not properly installed (question the chain problem). No matter how safe they are used, it is unwise to drive tyres with chains at 40 mph. The bad weather will not last forever, so when it is no longer snowing, you should remove the chain from your car. Under no circumstances should you drive on a road without snow with a chain, which will seriously damage your tires. It is much easier to remove the chain than to install it. Just follow the opposite steps, remove the chains, and store them in a dry place for the next winter.